Given below are some checkpoints which will guide the technicians about some common deficiencies in the blow room and the corrective action to be taken in such cases with regard to quality control, maintenance or work practices. Mixing Room Opening and Cleaning Scutcher End Thus, if the technicians make it a point to inspect the […]
Conventional and Modern Lap Preparation Techniques
Sliver Lap Machine 20 carded slivers in cans are assembled at the back of the machine and led side by side along a polished table, passing through assisting rollers and a stop motion device. They enter the drafting section, which gradationally has three lines of rollers. The slivers are subjected to a draft of about […]
Changes to be Made in a Speed Frame when a Certain Hank is Made Finer
Suppose, a certain hank is made on a machine and it is desired to change to a higher count. The same sliver or roving is used in the creel. The necessary changes are as follows: Draft: This must be altered in order to make the delivery roving finer. The draft change pinion (D.C.P) will therefore be […]